3D Drucker: Unterschied zwischen den Versionen
Aus Hand.Werk.Stadt WIKI
Georg (Diskussion | Beiträge) |
Georg (Diskussion | Beiträge) |
||
(12 dazwischenliegende Versionen von 2 Benutzern werden nicht angezeigt) | |||
Zeile 1: | Zeile 1: | ||
+ | <div style="float:right">__TOC__</div> | ||
+ | |||
+ | == Drucker im 3D Druck Labor == | ||
+ | |||
+ | * 1 x Prusa i3 MK3s | ||
+ | * 4 x Ender 5 Pro<br /> | ||
+ | =Slicer Software= | ||
+ | *Slic3r https://slic3r.org/ | ||
+ | *PrusaSlicer https://www.prusa3d.com/prusaslicer/ | ||
+ | *Cura https://ultimaker.com/de/software/ultimaker-cura | ||
+ | *Simplify3D https://www.simplify3d.com/ | ||
+ | |||
+ | =3D Design Software= | ||
+ | |||
=Webseiten für 3D Modelle= | =Webseiten für 3D Modelle= | ||
Zeile 18: | Zeile 32: | ||
|Modellbibliothek, großteils kostenpflichtige Modelle | |Modellbibliothek, großteils kostenpflichtige Modelle | ||
|} | |} | ||
+ | |||
+ | |||
+ | ==Einstellungen== | ||
+ | |||
+ | ===Support Einstellungen für Prusa=== | ||
+ | |||
+ | https://forum.prusaprinters.org/forum/prusaslicer/prusaslicer-hard-to-remove-supports/ | ||
+ | |||
+ | *0.25mm z distance. | ||
+ | *75% xy distance. | ||
+ | *3mm support spacing. | ||
+ | *4 interface layers. | ||
+ | *0.2mm interface layer spacing. |
Aktuelle Version vom 22. April 2021, 11:50 Uhr
Drucker im 3D Druck Labor
- 1 x Prusa i3 MK3s
- 4 x Ender 5 Pro
Slicer Software
- Slic3r https://slic3r.org/
- PrusaSlicer https://www.prusa3d.com/prusaslicer/
- Cura https://ultimaker.com/de/software/ultimaker-cura
- Simplify3D https://www.simplify3d.com/
3D Design Software
Webseiten für 3D Modelle
Titel | Link | Bemerkung |
---|---|---|
Thingiverse | https://thingiverse.com | Große Sammlung an gratis 3D Druck Dateien, hier findet sich fast alles. |
MyMiniFactory | https://www.myminifactory.com/de/ | Ebenfalls große Sammlung an gratis 3D Druck Dateien, hat aber auch einen Shop für kostenpflichtige Modelle |
Cults3D | https://cults3d.com/en | Modellbibliothek, großteils kostenpflichtige Modelle |
Einstellungen
Support Einstellungen für Prusa
https://forum.prusaprinters.org/forum/prusaslicer/prusaslicer-hard-to-remove-supports/
- 0.25mm z distance.
- 75% xy distance.
- 3mm support spacing.
- 4 interface layers.
- 0.2mm interface layer spacing.